MTB Bicycle Brake Rotor 120 140 160 180 203mm 6inch Stainless Steel Hydraulic Brake Rotor MTB Road Bike Disc Brake With T25 Bolt

Disc Brake discZTTO Bike brake parts 6 Inches stainless steel bicycle rotor disk for MTB road bicycle brake parts120mm/140mm/160mm/180mm/ 203mm【Name】 ZTTO Disc Brake disc[Specification] 120/140/160/180 / 203mm                  Disc thickness 1.9mm[Contains] 1 piece with 6 screws per piece[Benefits] All the disc brake hubs can be used,Disc Brake / wire Disc Brake can be used, the disc has good rigidity, fast heat dissipation, reflected in the long distance downhill, the disc will not be redheaded Hot, greatly improve the safety when going downhill!Installation screw hole distance: the distance between adjacent 2 holes is 2.2 cm, and the distance between diagonal 2 holes is 4.4 cm (this is the standard screw hole specification of the disc brake hubZTTO MTB Disc Brake Adapter7075 light weight high-strength aluminum alloyT6 hardened treatmentFor MTB Road Line Pulling Hydraulic Disc BrakeIS/PM TO PM140/160/180/203mm Brake disc rotorFree Gift is spacer and screwREPAIR HELPSteps1. Remove the wheel.2. Remove the used disc from the wheel.3. Clean hub and new disc with isopropyl alcohol. Ensure that the hub threads and hub mounting surface are free of dirt and grit.4. Place the disc on the hub mounting surface with the markings facing outward from the spokes. Ensure the arrow the disc is pointing in the direction of forward wheel rotation.5. Install all 6bolts and snug evenly.6. Tighten the disc screws (×6) in a star pattern to 6 Nm.Caution: Do not over tighten the disc screws, to prevent damage to the threads, disc or screws.7. Reinstall the wheel.8. Spin the wheel to ensure that the disc is not rubbing against the brake pads. If the disc rubs, re-align the caliper. Refer to the Brake Installation and Set-up instructions, as needed.