Stanley 8-pcs Brad Point Wood Drill Bit Set Model STA56006-QZ

Stanley 8-pcs Brad Point Wood Drill Bit Set, Model STA56006-QZ About this productThe Stanley 8-piece Brad Point Wood Drill Bit Set is a high-quality Stanley Wood Drilling Set curated for precise, splinter-free boring in softwoods, hardwoods, laminates, and plywood. Design and Features:Brad Point Tip Design: Each bit is engineered with a sharp, protruding center spur that instantly bites into wood grains, completely eliminating "bit walk" for dead-center hole accuracy.Peripheral Cutting Spurs: Features twin outer cutting spurs that cleanly score the perimeter of the hole before the main flutes remove material, resulting in smooth entry holes with minimal fiber tear-out.Chrome-Vanadium Steel: Roll-forged from premium Chrome Vanadium (Cr-V) alloy steel, ensuring maximum strength, durability, and resistance to heat buildup under load. Product Specification:Brand:StanleyModel:STA56006-QZAccessory Type: Brad point (spur point) wood drill bit setPiece Count: 8-piece selectionIncluded Sizes (Diameter): 3.0 mm, 4.0 mm, 5.0 mm, 6.0 mm, 7.0 mm, 8.0 mm, 9.0 mm, and 10.0 mmMaterial Composition: Premium Chrome-Vanadium (Cr-V) alloy steelShank Profile: Standard cylindrical round straight shank (matches bit diameter)Target Materials: Hardwoods, softwoods, plywood, laminates, MDF, and chipboardStorage Inclusions: Heavy-duty, plastic index case with labeled size slotsCompatible Tools: Corded and cordless power drills with 10mm (3/8") or 13mm (1/2") chucks Instructions for use:Bit Selection & Fitting: Open the labeled index case, select the required diameter (3–10 mm), insert its cylindrical shank deeply into your drill chuck, and tighten the jaws evenly to prevent slipping.Accurate Positioning: Press the sharp center brad point firmly onto your pencil-marked crosshairs to anchor the bit, ensuring it stays perfectly centered without walking when you start drilling.Controlled Feed Rate: Maintain a straight, 90-degree angle to the workpiece, start the drill at a medium speed, and lift the bit slightly out of deep holes periodically to clear wood shavings from the flutes. Precautions for use:Wood-Only Application: Restrict usage exclusively to wood, plywood, MDF, chipboard, and soft plastics; drilling into stone, metal, or masonry will instantly dull and destroy the outer cutting spurs.Rear Breakout Protection: Secure a scrap piece of wood tightly underneath or behind your workpiece before drilling completely through to support the wood fibers and eliminate back-side splintering.RPM Management: Adjust your drill speed relative to the bit size and wood density (slower speeds for larger bits and dense hardwoods) to avoid frictional overheating and burning the wood.