XMSJ | DF-8 Enameled Wire Stripping Machine Varnished Wire Stripper Enameled Copper Wire Stripper 220v EU

DF-8 Enameled Wire Stripping Machine, Varnished Wire Stripper, Enameled Copper Wire Stripper 220v EUModel: DF-8 Voltage: 20V 50Hz Wire diameter: 0.3-3.0mm Power: 75W Speed: 12000 r/min Length: 2-50mm Weight: 0.75kg Size: 255 * 55mmPaint scraper Wire diameter: 0.3-3.0mm Size: 255 * 50mm Net weight: 800g lithium battery Capacity: 2000mA Voltage: 12VPrecautions for lithium batteries Lithium batteries need to be charged in a timely manner, and being in a "low power" state for a long time can easily cause battery damage Damage, it is recommended to charge once a month. Lithium batteries should avoid contact with corrosive substances, Keep away from ignition and heat sources.matters needing attention 1. When the enameled wire has different specifications, the speed regulation potentiometer at the rear end can be adjusted (the slowest speed in gear 1, 6 The gear is the fastest, with smaller wire diameters adjusted towards the "slow" direction, while larger wire diameters adjusted towards the "fast" direction Adjust, when the paint film on the enameled wire cannot be completely scraped off, increase the speed until it is scraped off. If paint If the envelope is cut by a scraper during speed regulation, the speed should be reduced until it meets the requirements. Press up By selecting the most suitable speed as the working speed for the corresponding wire diameter, it can be considered that the adjustment has been made Okay. When scraping the paint to the end position of the enameled wire, do not immediately detach the end from the blade, wait for the blade to stop After stopping rotation, detach from the blade to prevent the enameled wire from suddenly detaching from the blade during rotation and damaging the blade. Before scraping the enameled wire, it must be slightly straightened by hand to avoid misalignment of the enameled wire with the center of the blade. 4. After prolonged use, if the power supply is not available, the safety cover can be unscrewed to remove the scraped paint Film powder.