Universal 7D Shark Fin Car Antenna Auto Radio FM/AM Aerial Styling Suitable for HONDA Jazz CR-V CRV CR V Civic Prologue Accord

p{margin-block-start: 0; margin-block-end: 0}7D Universal Auto Shark Fin Antenna Car Radio Antenna Aerial Receiver for Many Car ModelsFeatures and specifications:Shark fin antenna made from ABS plastic. Features a double adhesive for a strong hold.Note:The shark bottom hole measures 9.8cm/3.86inch x 5.2cm/2.05inch. Please make sure your antenna base is smaller than that to ensure fit. Otherwise,it can not install.The Bottom is flat.old.Shark size and bottom hole size:Shark fin:Length 15.3cm(6.02inch),Width: 6.84cm(2.69inch),Height: 6.4cm(2.52inch)Bottom hole:Length: 9.8cm(3.86inch),Width: 5.2cm(2.05inch) install. Packing list:Shark antenna body 1 piece.Screw M5x10 1 piece.Nut M5 1 piece.Double adhesive 1 piece.Shark show: Shark Colors Show: Easy to install①Remove the original antenna,clean the area around the antenna base.② Heating double adhesive,stick the double adhesive onto the bottom of the shark fin.③ Tighten screw and nut on the original antenna base.④ Carefully align the shark fin and press down for 2 minutes to assure adhesion.Frequently Asked QuestionsQuestion 1:Is the shark same color with original car color?Answer 1:Shark fin color very close the original color,however, the car due to long-term exposure to outdoor, erosion by rain and snow,the color has changed, so impossible exactly the same as color,please understand.Question 2:The shark installed on the roof have a little gap, is appropriate?Answer 2:The shark bottom is flat,without curved,most of car models no have gap,few sedan models roof is large curvature,there may be have a little gap,it does not affect the use.You can use adhesive in to the gap.Question 3:How about the radio signal effect after installation?Answer 3:This antenna using purification copper fittings,through our tested,the signal close to the original car antenna.Question 4:What should be note when installing?Answer 4:Clean around antenna base,be sure not have water and dust,first connect the cable and base,test the radio,if it is ok,than installing,heating double adhesive with hair dryer before you install,it will become soft,viscosity will increase,only have one chance to paste,so be sure to alignment the position pressing 3 minutes after pasted,keep dry in 2 days.