5pcs Screen Protector Film Scratch-Resistant Protective Films For Phrozen Mighty 8K 12K LCD Resin 3D Printer Accessories

About this itemCompatible models: 10.1-inch tempered glass screen protector, compatible with Phrozen Mighty 8K, Phrozen Mighty 12K, Elegoo Saturn 3, Saturn 4, Saturn 4 ultra, Saturn 3 Ultra, Saturn 8K, Saturn 2, Photon M3 Premium LCD resin 3D printer.Light transmittance: The light transmittance of the tempered film is greater than 96.9%, which will not affect the light emitted by the monochrome screen to pass through the tempered film to cure the resin in the resin tank.Protection: The tempered film has a good protective effect. It not only protects the monochrome screen from being scratched by sharp objects in daily use, but also prevents the release film from being damaged and causing resin leakage to contaminate the screen.Easy to install: Easy to use, there is a protective film on the back of the tempered film. Please keep the screen clean before use, then tear off the protective film on the back and install the tempered film on the monochrome screen. Use a plastic scraper to avoid bubbles. After installation, please wipe the tempered film clean with cleaning fluid and non-woven cloth. (Only equipped with a scraper)Tip: To avoid printing problems, it is recommended to level the 3D printer again after installing the tempered film.Add replaceable protective filmThe resin liquid leaks directly, and the screen protective film effectively prevents damage to the LCD screen.Good ProtectionThe screen protector can protect the screen from scratchesAnti-scratchThe anti-scratch film can prevent the screen from being scratched during the movement of the resin tank.96.9% HighTransmittanceEnsures high stability of UV lighting and won't affect the printing resultInstallation Of LCD Screen Protector StepStep 1.Tear Off the stained screen protector and clean the curing screen with tool kit.Step 2. Peel off the backing of the screen protector. Align the protectorwith edge of screen and stick it from one end to the other with plastic scraper.Get the installation carefully with out air bubbles.Step 3. Use plastic scraper to remove remaining bubbles by pushing each bubble to the edge of screen slightly. Smooth down the screen protector and peel off the front cover to finish.