Meander design DIY black re usable mold pathway maker hard plastic size 30x30x2.5cm

Lazada DIY pathway MakerBricks making made easy.Hard plastic mould DIY projects. No big machines needed in order to beautify your home. If you buy from us, we will assist you step by step instructions in bricks pavers making. We also supply pigments Red yellow white and other colors. Pavers helped absorb water. Water permeate in between. We also assist in bricks pavers installation and set up. Smooth surface are easy to clean, just like tiles.High strength of the pavers allows for heavier loads and longer life than that of standard cement No flooding, water moves or permeates in between pavers or bricks. It’s easier to put under ground cables, water pipes, etc. if you installed pavers compared to concrete. Just lift the paver where the pipe, cable will pass through then you return back the pavers without destroying your home pavers installed.NO need of big machines mixers to beautify your home, just your hand + plastic mold + trowel!Why buy expensive pavers??? wherein you can DIY (do it yourself) it !!!Pour fresh cement on the mold then dry if for 48 hrs, then demould using your hand. MIx 1:2 ratio 1part cement vs 2part sand (1:2 ratio) plus little water until become fresh cemento Shake the mold and flatten up to the level of mold using hand trowel. The more molds you have the better for easy finishing your project. In adding colors to the bricks to become Red bricks or other color you want you can chat us. Ladies you can do it too!!!!Note: for adding color (product link https://s.lazada.com.ph/s.ZZhnqD to your bricks, just add 15% pigments, example in order to produce Red Brick. Example: 5 cups of cement + 15 cups of sand + 3 cups Red oxide pigments, (15% pigment) + little water mix all together thoroughly then pour the red sticky grout (cement+sand+pigment+water) in the mould and dry for 48hrs.If you buy 10 from us we will have your support anytime. Other supplier does not offer you this type of suggestions on how to do it!Note: If in case the mold will stick to the cured cement during demolding after 48hrs, spray or paint brush (1 inch) the "in sides" and bottom of the mold with liquid release agent (available also online here which is more cheaper than cooking oil Product Link https://s.lazada.com.ph/s.ZZhNr1 during brick making.