3D Rainbow Window Film Privacy Mosaic Decoration Static Cling Adhesive Film UV Blocking Heat Control Stained Glass Stickers

AFDB window film use glue-free materials, easy to install, gives privacy and decorate while allowing plenty of light in. Meanwhile, AFDB window film will block 96% of UV-Rays,protect your skin and furniture.Privacy Effect for Different Distance This pattern of window film will provide you a good privacy. It is highly recommended for the privacy needed place, such as a washroom ,bedroom or basement window. You will love to have a DIY with it to decorate your kitchen, living room and front doors etc. Let's go to dress up you windows!Tips for Installation:A clean and smooth glass surface without any dust, fiber or any kind of texture is needed.The transparent back cover must be peeled off; otherwise, the film will fall off when the water is dry.Do not apply to the window frame. Cut off excessive edges after application if needed.The film may be a little tough and its adhesive effect will be impacted in winter. Solution: use hair dryer or warm water to soft it. ( Heat resistance is under 176℉).EnviromentalAll materials of Cottoncolors Window films are NON-TOXIC and pollution-free.RecyclabilitySelf-sticker (No-glue) design makes the window film reusable.Keep the glass clean.ReputablyExcellent texture provides you with privacy and beauty at the same time.1.Clean the window glass.2.Wet the window glass with soapy water.( PS: Mix a little soap or detergent with a lot of water)3.Measure windows and trim film.4.Affix tapes on both sides to remove the transparent backing film. (PS: It is a very important step that the window film cannot be stuck if it is ignored)5.Install the film to the glass.6.Squeeze out water and air bubbles with a smooth tool, such as a credit card or a spatula. (No spatula or squeegee is included in this item).Q & AQ1:Why the window film can't stick to the window(falling down)?A1: There are so many reason which will be caused window film falling.1.The transparent backing film didn't peel off; 2.The window glass is not smooth; 3.Too less water when install the film;4.Applied the wrong side.Please apply the smooth side to the window.Q2: Why there are so many bubbles in the window film?A2:Please spray more soapy water on window,and repaste it again.Q3: Why the edge of window film curling up?A3: The edge of film is paste to the window frame. Please leave a small gap(2-3mm) between the film and frame.The cold weather also may affect the application. Please try to blow the films with a hair dryer or soften it by soaking in warm water. Set a hairdryer to high heat with low speed and run it over the film, holding 1"-2" (2.5-5cm) away from the film surface.