【BOLT】18L Autoclave Retort Machine – Stainless Steam Medical Sterilizer Dual Heating Disinfect Device

【Features】Made of high-quality 304 stainless steel, which is durable and practical.heating and electric heating dual heat mode, convenient to use.Adopt wrought iron flange to reinforce, making it more stable and safe.Overpressure self-release (0.145-0.165MPa) to prevent excessive pressure in the pot and ensure safe operation.Double scale pressure gauge is more convenient to read, plastic glass is explosion-proof and shatterproof.The good sealing effect, high temperature, and pressure increase quickly.【Specification】Sterilizing Volume: 18LPower: 220V/50HzPower output: 2.0KWOverpressure Auto-discharging:0.145-0.165MpaRange Of Measurement: Max. 126°C-128°CControl Mode： MechanicalMaterial: Stainless Steel 304Color: Silver【Operation】Step 1. Place the sterilizer on a flat surface.Step 2. Open the lid, take out the inner tank of the sterilizer (you can see the heating electric tube), add water to the heating tube above 3.5L, and add enough water in time to burn the electric tube to lacking water.Step 3. Put those items that need to sterilize into the sterilization room, you should keep gaps between the items. Do not block steam holes of the safety valve, and air-releasing valve, and finally, cover the lid, and tighten the screws.Step 4. After the normal operation of the equipment, when themeasured temperature reaches 105 degrees, open the air-releasing valve to discharge cold air inside the sterilizer. When the air releasing valve start going out a little hot steam, close the air releasing valve.Step 5. When the steam pressure reaches 0.142-0.165MPa, the safety valve will start pressure relief work to maintain a certain pressure.Step 6. After sterilization, unplug the power cord. 3 minutes later, open the air-releasing valve, when the pressure gauges to zero, open the lid to discharge the remaining air.【Safety Measure and Maintenance】1. This sterilizer is a steam pressure vessel so do not impact in use and forbids overpressure. This sterilizer wouldn't stop heating when it is working and can't be timed as well. Please accompany it when it is working in case of water in the pot boiled away. If the pressure pointer of the pressure gauge reaches 0.165MPa and the safety valve does not exhaust, it should stop using it at once and check the safety valve.2. The pointer should be at zero position before usage of the pressure gauge, otherwise, the gauge has been a failure and it should repair or replace the gauge. The pressure gauge should be regulated 1~2 times per year, ensuring sensitivity and correctness.3. Gasket is easy to wear. If it does not work well, see it become aging and hard, then replace it in time.【𝐏𝐚𝐜𝐤𝐚𝐠𝐞 𝐈𝐧𝐜𝐥𝐮𝐝𝐞𝐝】1 x Steam Sterilizer1 x Power Cord1 x US Plug Adapter1 x Accessory1 x Manual