RF 433MHz Wireless Switch No Battery Required Remote Control Wall Light Lamp Switch

Product parameters:Controller（Receiver）Working voltage:100-250V 50/60HzCurrent: 10AController size: 67 x 41.2 x 25.7 mm. (Body Size: 47.4x41.2x25.7mm)Material: ABS+PCPanel Switch ParametersFeatures: No battery, built-in power consumptionSize: 86x86x16.5mmButtons: 1 button, 2 buttons, 3 buttonsRemote Control Distance: Indoor about 20-30 meters and outdoor 10-50 metersWhat is the self-propelled switch?Self-powered wireless switch panel, press to build power by yourself, no wires and no power supply, self-built power for self-use, energy-saving and eco-friendly products, the service life is pressed more than 100,000 times, use with power on/off controller (electric equipment).Advantages:1. Save wires and save labor, no risk of electric shock and combustion without exposure to electricity, labor, no internal heat source and no influence on increased temperature.2. The controller can match multiple free sticker switches at the same time, so that one light can switch several lights! Solve the problem, no switch on the bed, turn on the light at night, unreasonable circuit design, inappropriate switch height for the elderly and children at home and inconvenient wiring at home due to deterioration of wiring!3. After power failure, the power goes off itself to avoid consumption of electricity and will not interfere with each other. Use digital encryption and decoding technology and no direction. High performance processing chip, built-in relay control, safer and more stable, superherodynamic herodynamic relay module, ultra low power consumption, strong antiinterference and sensitivity.High!Learning settingsThe packaged product has been paired at the factory, so this operation is not required. If you need to add or replace the remote Pairing methodLong press the receiver learning code buttonM for about 3-5 seconds, the indicator light is always on, enter the pairing mode, press theremote control switch at this time, and the receiver indicator light flashes, the code is successful.Clear function：Long press the receiver learning code button for about 8-10 seconds, and the indicator light flashes quickly to clear the code successfully.Controller (receiver) status settingController default open state setting: You can press the controller button to turn on the light. After 15 seconds, press the controller button again to turn it off. When powered on again, the controller will be in the on state.Controller default off state:You can press the controller button to turn off the light. After 15 seconds, press the controller button to turn it on. When powered on again, the controller will be in the off state.