TAIFU Hybrid Solar AC/DC Deep Well Pump (3" Diameter) - 1.0HP | 1.5HP | 2.0HP (UNIT ONLY)

The TAIFU Hybrid Solar Deep Well Pump range (including the 1.0HP, 1.5HP, and 2.0HP models) is designed for versatile water extraction using both DC (Solar) and AC (Grid/Generator) power. These 3-inch pumps are ideal for narrow boreholes where high lift is required in off-grid or energy-conscious locations.The "Hybrid" functionality typically means the external controller can automatically switch between solar power during the day and AC power (grid or generator) at night or during cloudy weather.Key Features & TechnologyDual Power Input (Hybrid): Can be powered directly by solar panels or by a 220V AC source. The intelligent controller manages the power source to ensure continuous operation.Brushless DC Motor: High-efficiency, permanent magnet motor that offers roughly 25% better efficiency than traditional AC motors.MPPT Controller: The included controller features Maximum Power Point Tracking to squeeze every bit of energy out of your solar panels, especially in low-light conditions.Full Protection Suite: Includes protections for over-voltage, under-voltage, over-current, and high temperature, as well as dry-run protection (stops the pump if the well is empty).Soft Start: Prevents water hammer and extends motor life by slowly ramping up the speed upon startup.Technical Specifications (3" Series)Model Feature1.0 HP (750W)1.5 HP (1100W)2.0 HP (1500W)Max Head (Lift)Up to 110 – 125mUp to 140 – 155mUp to 170 – 180mMax Flow Rate~3.8 – 4.0 $m^3/h$~3.8 – 4.2 $m^3/h$~3.8 – 4.5 $m^3/h$Voltage RangeDC 72V – 110VDC 110VDC 110V – 150VAC Input220V Single Phase220V Single Phase220V Single PhaseOutlet Size1.25" (32mm)1.25" (32mm)1.25" (32mm)Materials of ConstructionBecause these pumps are designed for deep submersion, TAIFU uses premium materials to resist corrosion and wear:Pump & Motor Body: High-grade AISI 304 Stainless Steel.Impellers: Typically Stainless Steel or high-strength PPO (Plastic) stages depending on the specific sub-model (the "TSC" series often uses plastic impellers for sand resistance, while "TSS" uses steel).Shaft: AISI 316 / 304 Stainless Steel to prevent rust and handle high torque.Bearings: High-precision Japanese NSK bearings for quiet operation and long life.Screws/Nuts: AISI 316 Stainless Steel for maximum salt/mineral resistance.Solar Panel RecommendationsTo get the best performance, it is generally recommended that the Solar Panel Wattage = Pump Power x 1.3 to 1.5.1.0 HP (750W): Recommended ~1000W to 1200W of solar panels.1.5 HP (1100W): Recommended ~1500W to 1700W of solar panels.2.0 HP (1500W): Recommended ~2000W to 2200W of solar panels.WARRANTY INCLUSIONS & EXCLUSIONS ● 7 days replacement against factory defect is subject to approval by our authorized personnel only after diagnosis by our authorized technician.● Warranty does not apply to failures due to; human error, mishandling, misuse of any unit are not cover for replacement.WARRANTY CLAIM ● Fill out our warranty card attached to the manual inside the box with general information like Date, Model no., Serial no., and Contact no.● Serial number on the unit must match the one written on the warranty card.● Bring your warranty card or any proof of purchased when claiming the warranty.