LEBYCLE | LEBYCLE Bicycle Tubeless Rim Tapes Width 21-36mm*10M Bike Rim Tape Strips For MTB Road Bike Wheel Durable Bicycle Accessories

LEBYCLE Bicycle Tubeless Rim Tapes Width 21-36mm10M Bike Rim Tape Strips For MTB Road Bike Wheel Durable Bicycle AccessoriesProduct Parameters //Brand :LEBYCLEName :Tubeless Rim TapeModel :TB-TT02Height:21MM 24MM 27MM 30MM 33MM 36MMPackage Dimensions :9.29.2*3.7CMLength :10m/roll (boxed)Material:PET+SiliconUse:6 different widths to fit most rims, mountain/road/gravel and plus size rimsHow to choose the correct width of rim tapeExampie: If the measurement of 25mm width recommended to choose the rim tape width increased by 2-4mm that is,choose 25+2-27mm(as shown in the picture for the hookless rima)Modet A with hooked rims reconmended inner width+4MMModel B fiookiess Rims Recommended Inner Width +2MMModel A:Hooked rimsModel B: Hookless rimsHigh toughness High tensile strength Great fit, flat, not out of place.When applying the rim tape, it is necessary to pull slightly so that the rim tape will fit the rim flatly and there should be no air bubbles on the inside of the rim.High pressure resistanceThe test subject is a road bike 700C vacuum outer tire whose maximum air pressure is 120psi The test hit a high pressure value of 130psi and no air leakage was observedTear off without residual adhesiveBetter adhesive material No adhesive residue after removaI Clean and easy to clean upWrapping illustrationTake the valve hole as the center, from the third spoke hole on the left side (about 10cm away from the valve hole) wrap it around once, and then end up at the third spoke hole on the right side of the valve hole (you can also wrap it around 2 times).Installation steps1. Clean the surface of the inner rim, and start winding from about 10cm away from the air nozzle hole; the winding process needs to be pulled hard to fit the rim (if there are bubbles, you can pull up and re-paste)2.Wrap it around the inner circle 2 times and finish attaching it Cut off the excess with scissors;3. Use a hobby knife to cut a "ten''or "one" opening in the air nozzle hole;4. Vertically install the vacuum air nozzle into the rim nozzle hole then screw the nozzle cap/nozzle washer onto the nozzle, finger tighten the nozzle screw cap, the nozzle installation is complete,fill with self-adhesive fuid, and install the outer tire to pump.