DEKES 4500W Feed pellet machine 220v small dry and wet straw crushing granulator pelletizer machine feeds Breed

Pelletizer machine feeds Feed pellet machine 220v small dry and wet straw crushing granulator Item model number: 125(2 rollers)Motor: copper wireYield: 90-120KG/HVoltage: 220VPower: 4kw/5.5hpAmount of water: 0-2kgSpecifications: 287564cmWeight: 70kgItem model number: 160(3 rollers)Motor: copper wireYield: 150-200KG/HVoltage: 220VPower: 4.0kw//5.5hpAmount of water: 0-2kgSpecifications: 1006035cmWeight: 85kgItem model number: 180(4 rollers)Motor: copper wireYield: 200-300KG/HVoltage: 220VPower: 4.5kw/6hpAmount of water: 0-2kgSpecifications: 1056540cmWeight: 86kgIncluding 2 grinding plates (4 mm/6 mm)4mm (applicable to fish, chicken, bird, peacock, cat, rabbit, etc.)6mm (applicable to dogs, sheep, pigs, cows, deer, bears and other large animals)Wooden case sealed packagingNote: When you open the machine for the first time, you need to fill the middle of the water tank glass with heavy lubricating oil.Precautions:1. When using, it should be noted that there should be no hard foreign objects such as stones and iron blocks in the raw materials. After working more than ten times on the pressure roller, it needs to be disassembled, and high temperature resistant grease should be added to the bearing to make the pressure roller work well and prolong the bearing capacity. service life.2. It is strictly forbidden for the pressure roller and the template to contact idly during the pulling process. The continuous feeding should not be too fast, not too slow, or interrupted. At the same time, lock the uranium nut of the pressure roller to avoid loosening and damaging the main shaft keyway.3. If the particles are broken or not compacted, the fiber feed formula should be reduced to less than 50%, and the moisture content of the raw materials should be less than 20%.4. If there is no granulation and no material during granulation, the template should be removed, and after the hole is opened, some fiber feed is appropriately added to restart the granulation port.5. Always check the tightness of the screws in various parts of the machine. If there is oil leakage in the gearbox, replace the oil seal immediately and check whether the bearings in the machine head are short of oil.6. When the pellet machine is working, do not put your hand into the feeding port. If necessary, you can use a wooden stick to help feed the material.7. Before the machine is turned on, it is necessary to add less material first, and then turn it on. When the machine is turned off, a little feed should be left in the machine to prevent the machine press roller from idling in contact with the grinding disc.8. If the ejector is stuck during operation, it should be stopped immediately, and the pressure roller should be pressed until the bolts are loosened, and then restarted.9. After each work, the adjusting roller bolts must be loosened.