【Free Knife + Scraper】2M Ceramic Nano IR Window Film One Way Mirror Window Film Blocks 99% of UV rays UV-proof Heat-proof Car Light Filtering Film Window Tint Film Privacy Film Tint Blackout Stickers Glass Sticker for Home and Office Spot goods

√ 100% genuine licensed goods√ Payable destination√ Welcome to return / replace products within 7 days of receipt (in case of production problems)Product Detail Information:1.Product: Heat Resistant Glass Film Light Filtering Increase Privacy2.Material: High Efficiency PET Polyester Film3.Size: Width 90CM x Length 200CM (It is a roll success. It has a paper core in the middle, reduce the problem of damaged goods during transportation) Width 60 cm x Length 200 cm (It is a roll success, with a paper core in the middle, reduce the problem of damaged goods during transportation)Benefits of lighting filtering film heating reduction:1. Reduce glare, reduce heat and prevent UV radiation2. Reduce the cost of electricity. Allow air conditioning to not work hard.3. Establish modern prominence for film-mounted buildings4. Create privacy without obscuring the view. One way film, see through one side (less light side).5. Can reduce the heat of sunlight from entering the building.6. Make the house bright, even sun proofHow to calculate the number to stick:1.Mirrors up to 60 centimeters long, 2 meters long, 60 90 centimeters wide face can be used.2.Mirrors up to 89-90 centimeters long, 2 meters long, can use a 90 centimeters wide face.3. If there are many mirrors, buy according to the number of mirrors.4. If the width and length are not enough, the pattern can be joined together.🟣 film installation method: 🔺 turn off the fan or air to prevent the entry of air. 1) Wash the glass and remove the dirt along the glass skin with a scraping knife. 2) Peel the adhesive side clear plastic sheet, keep it out of the film (using transparent tape glued on both sides to the angle of the film) 3) Apply film and water mirror to soak with the water we mix 4) Put the film on the glass on the other side of the film and spray the water on the film again, and expel the water from the middle and further to the edge. 5) Cut the excess film around the side edges. 6) Wipe the glass dry and finish. 🔺 the film will dry completely after 3-5 days, so it can be cleaned normally.Important:1. The product will be one way mirror film. If the light is not turned on or the light is low, the outside will not be visible. But if the light is turned on or the light is brighter than the outside, the outside will be visible and the inside will be reflected.2. If there are bubbles, the stick can be fired.3. The transparent plate must be peeled off before sticking. If not peeling, the transparent plate will not stick. ⚠️⚠️ in paper tubes. This is a non-standard package, so sometimes damage may occur on the way. If you see that the courier brings you a paper tube with a pack, ❗️ the shop recommends that you reject the package and you will not lose anything, but you will save a lot of time. All products are checked before shipping. But if you find a defect in the film or an error in the execution of the order, please let us know in chat and we will send the new product immediately.