Spot Welder Adjustable Portable Handheld Mini Spot Welding Machine Automatic Trigger for 18650 Batt

Welcome to our store！！ Product name: Portable portable welding machine LCD: Power/gear/voltage/mode Gear adjustment :11 Battery type: Lithium polymer battery Battery capacity :5000 Mah Current design :650A (MAX) Input interface :type -c Charging parameters :5V /1A (MAX) Output voltage：4.2v(MAX) Nickel strip thickness :0.1-0.2 mm. Product size :43 * 25 * 192mm Product weight :250g Please NOTE Press the short key to start, press the long key to automatically close, do not need to work within 6 minutes. After the machine is started, the product will be in automatic welding mode for 2 seconds. When you are spot welding, the spot welding angle is recommended to be tilted 30 plating, presenting a 60° angle to spot weld, this angle is better. You can also try other angles, suitable for your spot welding angle is the best.Please read the instructions carefully after receiving the product. Use android phone charger to charge, 5V input (high voltage input is strictly prohibited), charge Currently, the 1A recommends a 5V / 2A charger, which supports charging while working. The location of the spot welder contact: When you spot weld fit, both spot weld pens must contact the material at the same time, not one spot weld pen contacted, the other did not contact. To both pens are in contact, the spot welding current will be output, there will be a spot welding reaction. Spot weld material should be smooth: When you spot weld the fit, pay attention to spot weld the material to be smooth, clean, spot weld the 18650 battery fit, must be laid flat on the battery, the battery and the material can't have a gap, if there is a little gap, use the spot weld pen to gently press the following, so that the battery and the material are in full contact. Q: What should I do if the spot welding machine suddenly stops working? A: During the spot welding process, if the spot welding machine suddenly does not work, please change the angle or use a gauze friction spot welding pen. It is necessary for both spot welding needles to come into contact with the material before spot welding. Check whether the current spot welding mode is automatic or manual. Please refer to our instructions on how to use manual mode If the length of the spot welding pen varies, please send us a message immediay. How to Use : The manual mode button of the spot welding machine is located on the side, which is the "ON/OFF Key" First, press and hold the "ON/OFF Key" for 2 seconds, Then press and hold the top "Gear Switching Key" for more than 2 seconds, and the indicator light will jump to Manual mode. Next, press the top "Gear Switching Key" , material 0.1, and you can use the minimum gear to practice. Later, add gears to see the effect and choose the gear you think is the best. Welding method: The welding head is in contact with the horizontal level at 60 degrees, and the two needles are pressed on the surface of the nickel plate at the same time Packing : spot welder 1 * data cable 1 * nickel sheet