150g Edge Sealing Adhesive Waterproof MildewProof Tile Gap Grout Sealant Filler for Sink Toilet

Specification: Color: White/Grey Material: Contains water, resin composition, the surface is smooth, for tiles, tiles at the gap, and tiles can be scrubbed together to prevent the black mold. Net content: 150g

Package List: 1*Tile Grout Sealant

Features: This product has strong adhesion, capable of withstanding heat pulses and cold shrinkage, preventing cracking.

Scope of application: It is suitable for the beautification of tile gaps, mosaic gaps, toilet corners, kitchen counter corners, stairs, bathroom floors and other gaps, as well as the repair of dirty, black, moldy, and tile cracks on the floor. It has the excellent performance of waterproof, non-blackening, scrub resistance and no color change.

Instructions: Clean the gap between the tiles. The depth of the gap should be 2 to 3 mm. If the gap is too large, it is recommended to first fill it with grout and then use the plastic steel putty. Open the bottle cap, remove the sealing aluminum gasket, and replace it with the pointed tip cap. After unscrewing the cap, hold the bottle upside down for about 20 seconds, aiming the pointed tip directly at the tile gap, and squeeze the putty evenly along the gap. (Note: You can also apply masking paper along the edges of the tiles and then squeeze out the putty, then remove the paper after smoothing the paste.) Use a small scraper (or press ball) to gently scrape back and forth several times to ensure the putty enters the gaps evenly. It is recommended to apply the putty multiple times to fill the gaps as much as possible. After scraping, remove the excess putty. It will naturally feel dry. The recommended drying time is 2-3 days, during which time the area should not be exposed to water. For large or deep gaps, apply the putty several times every other day.

Precautions: Before use, test a small area in an inconspicuous spot to check for any adverse reactions. Use the product normally after ensuring there is no negative effect. Depending on the environment, it may take about 2-3 hours for the plastic steel putty to solidify. After the putty has completely hardened, avoid exposure to water for 2-3 days, especially hot water. After opening, the putty can be used multiple times. Be sure to seal the bottle properly to prevent direct sunlight from affecting the product. Do not use if the product has been frozen. Keep out of the reach of children. If the putty gets into your eyes, do not rub. Immediately rinse with clean water and seek medical attention if necessary. If the product is not completely used after opening, rinse the tip with water before closing the cap to avoid clogging the nozzle with leftover putty, which could affect future use.