iCx Passive PoE Injector/Splitter

A Passive PoE (Power over Ethernet) Injector/Splitter is a device that allows power to be transmitted over an Ethernet cable along with data, without active voltage regulation or negotiation. Unlike Active PoE, which follows standards like 802.3af/at/bt, passive PoE simply delivers power based on the input voltage, making it a cost-effective solution for powering low-power network devices such as IP cameras, access points, MikroTik routers, and embedded devices like Raspberry Pi.PoE InjectorFunction: Combines power and data into a single Ethernet cable.Input: Typically a power adapter (e.g., 12V, 24V, or 48V) connected via a DC barrel jack.Output: PoE-enabled Ethernet port that sends both power and data.PoE SplitterFunction: Separates power and data at the receiving end.Input: PoE-powered Ethernet cable.Output: Two separate outputs – one for power (via DC jack) and one for data (via Ethernet port).Voltage Output: Matches the input from the injector (no conversion in passive PoE).Key Features of Passive PoE:✔ Non-standard PoE – No negotiation with the powered device.

✔ Requires correct voltage selection – Typically 12V, 24V, or 48V (ensure compatibility).

✔ Common for MikroTik, Ubiquiti, and DIY projects – Used in WISP setups and embedded networking.

✔ Max cable length – Typically 30-50m, depending on voltage and device power requirements.Would you like recommendations for a specific use case, like powering your MikroTik router?