Sony A7M3 A7MR3 Body Sticker Single Reflex Camera Color Modification Film Traceless Back Glue Protection PVC Material

★Preparation before posting: 1: Prepare tools: hair dryer (if there is no lighter), tweezers, paper cutting knife, alcohol bag, cleaning cloth. 2: Wash your hands, prepare a clean flat desk or workbench, sit down in a quiet and bright environment, and relax. ★Work in post: 1: After receiving it, remove the extra stickers according to the hollowed out in the drawing, and cut out all the internal round holes and special-shaped waste paper. 2: wipe the alcohol bag of the camera first in the sticker. After drying, you can study the corresponding position of each hole. 3: The correct order of most parts in the paste is: first paste the part with many holes, then paste the small area, start from the top, then paste the front and rear holes, then paste the bottom and skin. One to two stickers are heated with a hair dryer to smooth the edges. ★Note: 1: What is difficult to stick is the parts with many holes. Be sure to align them carefully. If the stickers are not correct, you can remove them for many tests. Carbon fiber is flexible. If it is about 1mm short, it can be lighter (hair dryer) heating for one or two seconds, if it is too large about 1mm, just heat it, and the extra part of the hand belly will disappear automatically. 2: Be sure to align the holes first and then press them by hand. If you encounter large porous stickers, you can try to cut two and a half from a fine point to reduce the difficulty of film sticking; If both ends have holes, the two ends are aligned with the hole position respectively and then leveled to the middle. If there is a bulge part that does not fit, the bulge part is eliminated by cutting, and it is OK to flatten it left and right. 3: press every few small pieces, and then heat the fixed corners. After all the work is finished, press the hair dryer again to ensure that each piece fits perfectly with the camera. This is a process to test patience. You must be patient and work quietly. Don't be anxious. It can be slow but you can't make do with it. I will wish the sticking machine success and protect the camera (lens) anti-wear, the overall effect of beauty camera.