HBR Wet and Dry Grinders Grind Peanut Butter Popular Grinders silver grinder Aluminum allo

NEW PORTABLE MILL GRINDER (FOR WET AND DRY PULVURIZER) Aluminum head to prevent from rusting(Rice, Coffee Beans, Corn, Peanuts) Volts: 220V 50-60HzMotor Power: 2.2 KwMotor Rotational Speed: 1400 r/min. Production Granularity: 25-100mesh Dimension: 46x25.5x28cmWeight: 38KgMotor: copper core140 sand tray pulping machine instructions: dry and wet dual use. It is suitable for grinding soy milk and tofu, small tofu, wet rice milk, glutinous rice flour, etc. A small amount can be dry ground, and more powder can be coke. The household power supply is 220v; the raw material block is less than 2 cm; friction, friction sound like a commercial vacuum cleaner; the pulverizer is not a precision instrument, and powder and water will leak near the head and shaft. The ratio with water is ready to use. It can be connected to a water pipe, but cannot make high-thickness paste; edible oil or water is added to the sesame paste; the sand mill is a pollution-free high-pressure plate, and a little sand will fall off when it is started. Rice and water test for half an hour. The induction motor is allowed to exist, and it belongs to the normal range at 36v; the thickness valve needs to be adjusted when the card machine is turned on, otherwise the coil will be burned; overloading of the motor is prohibited, and work for 1 to 2 hours rests.White: steel sheet grindingIt must be seen before use!Use: The machine needs to be turned up when empty, then adjust the thickness, and then slowly cut the material. The order cannot be reversed! (The blanking must be carried out slowly. Each machine has a thin iron sheet, which can control the blanking flow rate. It must be used.)At ordinary times, pay attention to keeping the environment dry, and adjust the thickness at the same time;To avoid the motor load caused by fine grinding of the clamping machine, when hearing the buzzing sound and no turning sound, immediately cut off the power and readjust the thickness: there are two reasons for the clamping machine:1. Adjust the thickness and tighten the grinding plate too tightly2. The blanking is too fastJam handling: power off immediately, adjust the thickness and readjust it in time